The old requirement of 1 1/2 inch pipe is not enough to handle the fast drainage of modern washers. A washing machine drain pipe must have a drain plug in it to prevent water from entering the machine through the drain hole.
A 1-1/4 inch plug must be installed in the bottom of the wash machine to allow water to drain out. If the plug is damaged, it may be necessary to replace the entire plug.
Table of Contents
What size PVC is used for a washer drain?
The 112 inch size is used to capture water that might flow out of a kitchen sink, bathroom sink or tub. The two-inch pipe can be used to drain a shower stall or washing machine, and it can also be used as a vertical stack for a kitchen sink. A three-inch pipe is used in homes to carry water from a faucet to a bathtub.
Are all washing machine drain hoses the same size?
All washing machines should use standard sizes and fittings. This rust will not affect the performance of your machine, but it will make it more difficult to clean. The best way to get rid of this rust is to use a rust remover, such as Rust-Oleum Rust Remover. It is available at most hardware stores and can be purchased online at www.rustoleum.com.
How much fall does a washing machine drain need?
The maximum horizontal slope is 3 inches per foot and the minimum is 1/2 inch per foot. Minimum and maximum floor and wall drain lengths are usually 36 to 38 inches and 48 to 50 inches, respectively. (b) The minimum vertical slope of a floor drain shall not be less than one-half inch. The maximum vertical slopes shall be determined in accordance with the following table: Minimum Vertical Slope of Floor Drain (feet) Max.
What diameter should drain pipe be?
The toilet drain pipes are usually 3 inches in diameter. sinks. The shower and bathtub drain pipes are usually 2 inches in diameter. A 1.5 inch drain pipe is required for sinks.
Can a washer and toilet share the same drain?
In some cases, you can drain a washing machine into an existing toilet drain. Adding a toilet to an existing washing machine drain is not a good idea. The washing machine drain lines have a smaller diameter than the toilet drain lines. Water can leak out of the machine and into your home if the toilet is connected to the washer drain.
Can you run a washer directly into drain pipe?
Draining a washing machine into a floor drain might be okay if it’s properly done and if the floor drain is not connected to a storm sewer. Plumbing should be used to connect the washer and the floor drain to prevent water from splashing out of the drain. If you’re not sure whether a drain connection is appropriate, ask your local building inspector.
What pipes are needed for a washing machine?
Usually, a washing machine has hot and cold water pipes extended with T-fittings to reach its supply hoses. You don’t have to cut off the water supply if you have a mini stop valve. The waste hose should be put into a standpipe with a P-trap. A dishwasher only has a cold water pipe and a hot water hose.
If you don’t have a stop valve, you’ll have to use a hose clamped to the side of the sink. This is a good idea if you’re going to be doing a lot of laundry, but it’s not a great idea for a regular wash.
