A minor clog should clear after a few strong pumps with a plunger. Go for it if you put the plunger cup in the drain opening. The plunger did not do the trick. Baking soda can be poured down the drain and then chased with a small amount of vinegar. You’ll be surprised at how quickly the clogs clear.
Table of Contents
Why is my drain in the basement backing up?
The main sewer line is connected to the drain. The point at which the water is most likely to find a way out of the house is the lowest point in the home.
If you have a basement drain that backs up into the basement, you may be able to get rid of it by filling it up with water. If you do this, make sure that the water level is at least three feet above the floor. This will prevent the drain from backfilling itself.
Can you snake a basement floor drain?
If you have a simple clog that only requires a drain snake, you could get away with paying as little as $5 for a snake at the hardware store if you already have all of the other materials in your home. You’ll need to use an electric drill to get between the drain and floor. Drill a hole in the bottom of your drain.
If you don’t have access to a drill press, a hand drill will work just fine. You’ll also want to make sure that the drill bit is at least 3/8″ in diameter, so that you can get a good grip on it while you’re drilling. I used a 1/2″ bit, but you may need a larger one depending on the size of drain you are trying to fix.
The hole you drill should be about 3″ deep, and about 1″ wide. Make sure to drill through all the way to the top, or else you won’t be able to drain the water out of it. Once you’ve drilled your hole, use a screwdriver to secure it in place. Be careful not to over-tighten the screw, as this will cause the pipe to break.
How do you unclog a basement drain without a snake?
A pot of boiling hot water and a cup of baking soda should be poured down the drain. Let that sit for a few minutes, then pour a mixture of one cup of vinegar and one cup of hot water on top of the baking soda. After five to ten minutes, flush it with another pot full of water.
Repeat this process until all the water has been flushed out. Once you’ve flushed the toilet, it’s time to clean up. First, you’ll want to wash your hands with soap and warm water, and then scrub the inside of your toilet bowl with a toothbrush.
You can also use a paper towel to wipe the bowl, but be careful not to use too much force. If you’re using a toilet seat, be sure to remove it from the seat before scrubbing. Once you have cleaned up the area, rinse it off with hot, soapy water and let it air dry.
How do you unclog a sewer line without a snake?
Pour a cupful of baking soda down the drain and you’re good to go. You can pour a cupful of white vinegar down the drain. Wait for around 10 minutes for the baking soda and vinegar solution to break up and mix together. Once the mixture has broken up, you can pour the solution into a container and store it in the fridge for up to a week.
How much does it cost to unclog a basement drain?
Depending on the hourly rates, accessibility, severity, and cause of obstruction, plumbing can cost between $75 and $550. A flat rate on basic drain cleaning is offered by most plumbing companies.
Where does the basement floor drain go?
A basement floor drain, also known as a foundation drain, is designed to drain excess water out of your basement. It could drain into your sewer line. If you have a basement, you may want to consider installing a drainage system to prevent water from seeping into the basement and causing damage to your home.
Should there be standing water in basement floor drain?
Basements are more susceptible than any other component of your home to absorb water because they are below grade. Standing water in your basement floor drain is normal, and it stops sewer gases from escaping into the house. If you have a basement that is not well-maintained, you may want to consider replacing it with a new one.
How do you unclog a severely clogged drain?
A lot of people are familiar with the baking soda and vinegar trick. If you have a plug, simply pour some hot water down your drain, cover it with a plug, then follow it up with equal parts baking soda and vinegar.
If you don’t have a drain plug, you can use a paper towel soaked in vinegar and water to soak the bottom of your sink. You can also use an old toothbrush or toothpaste tube, but be careful not to get any of the vinegar on the brush or tube.
When I flush the toilet water comes up in the basement?
Water going slowly through the pipes can increase the risk of a problem. If you suspect that you have a plumbing issue, contact your local plumbing company to see if they can diagnose the problem. If they cannot, they may refer you to a professional plumber.
