Depending on cam timing, valve lift, rocker arm ratio, and combustion chamber shape, it’s possible that the valves can touch the top of the piston as it reaches the top dead center. This is a very common occurrence, and it can lead to a loss of valve timing. If this happens to you, you’ll need to replace your valve springs and valve cover gaskets, as well as your timing belt and timing pulley.
Table of Contents
What happens if an engine drops a valve?
If your vehicle experiences a dropped valve, you’ll need to have the vehicle repaired as soon as possible. Driving a vehicle with a dropped valve for a short period of time can destroy the inside of a cylinder and cause other damage to the engine.
Will an engine start with bent valves?
An engine that won’t start, an erratic engine when idling, lack of engine power, a knocking noise from the engine and excessive exhaust fumes are some of the symptoms of bent valves. The fuel delivery and gas removal are controlled by engine valves. Bent valve problems can be caused by a number of factors, such as improper installation of the valve, improper fuel injection, or improper maintenance.
The most common cause of a bent valve is a leaky fuel injector, which can occur when fuel is injected into a fuel system that is not designed to handle high levels of fuel. This can cause fuel to leak into the combustion chamber and cause a valve to bend. If the leak is large enough, it can lead to a fire.
How much piston damage is OK?
A minor change in piston-to-wall clearance can be considered normal, but changes in the piston-to-wall clearance of more than 0.002-inch should be considered abnormal.
How do you tell if valves are bent after timing belt broke?
In order to check if you have bent valves, you will have to remove the timing belt and check the piston one by one when it is in the TDC position rotate the camshaft 720 degrees. If you didn’t encounter any resistance, you can check the second pistons. If the valves are bent, then you need to replace the valve cover gaskets.
You can do this by unscrewing the cover and removing the gasket. The valve covers are made of plastic and can be easily damaged if they are not properly cleaned and lubricated. It is recommended that you clean the covers before replacing them.
What happens if Valve clearance is incorrect?
Poor performance or a rough idle can be caused by too much or too little valve clearance because the engine can’t breathe normally and operate at peak efficiency. Over the long term, too much clearance will cause damage to the valves, camshaft lobes, and other parts of the valvetrain.
The best way to ensure that your engine is running at its best is to make sure that you have the proper amount of clearance between the intake and exhaust manifolds. If you don’t have enough clearance, you won’t be able to breathe properly and you’ll end up with an underpowered engine.
What affects piston to valve clearance?
The top of the valve reliefs and the combustion chamber should be cleaned. The better the clay is, the better it will stick to it. Remove the valve cover. Disconnect the spark plug wires. Use a small flathead screwdriver to pry open the intake manifold. Using a pair of pliers, pull the airbox out.
Pull the exhaust manifold out, as well. The intake and exhaust manifolds are held in place by four small bolts. Slide the throttle body back into place. Turn the ignition switch to ON. Replace the fuel filter. Reinstall the oil pan.
