If the bathtub pop-up drain stopper is stuck and simply won’t unscrew, use a pair of pliers around the round cap to wiggle it loose. It is possible to prevent damage by placing a soft cloth between the pliers and the top of the stopper. The left and right sides should be wiggled a few times to loosen it up.
Table of Contents
How do you remove tub drains with crossbars?
If your drain fitting has these crossbars, insert a drain wrench into the cross shape and turn counterclockwise to unscrew it. The best way to use the wrench is to use the side that offers the best fit. A pair of needle-nose pliers can be used to grasp the X and remove the drain plug.
If you have a water pump, you’ll need to remove the pump from the water line. If you don’t have access to a pump (or if you’re not sure how to do it), you can use a small screwdriver to pry the plug off the end of the hose. Be careful not to puncture the pipe, as this can cause a leak.
Is there a special tool to remove tub drain?
A plug wrench is a small wrench that is made of cast iron or steel and is used to fit two or more different sizes of drain. If you plan on removing your tub drain more than once, you should invest in a set of plug wrench.
How do I remove a bathtub drain flange?
If you’re removing the entire drain apparatus, you should put your drain key or smart dumbbell into the opening. Continue turning counterclockwise until the drain flange is released, then remove it while it’s still attached. You can also use a small screwdriver to pry off the top of the lid. If you don’t have a screw driver, you can use your fingernail or a pair of needle-nose pliers to pull it off.
Can you replace a bathtub drain?
It should take about an hour to remove and replace your bathtub drain. Gauge (if you don’t have one, you can buy one at your local hardware store for less than $10) (If you do not have a water pressure gauge, then you will need to purchase one from a local plumbing supply store.
You can find them at most hardware stores for about $5-10. We will be happy to help you find the right one for your situation.) (You will also need a new drain plug, if you haven’t already done so. The new plug should be the same size as the old plug and should fit snugly into the drain hole.
It should not be too tight or too loose, but not so tight that it will not allow water to drain out of your drain.
What is drain wrench?
Wrench removes most old tub and shower drains and helps during replacement installations. A heavy-duty aluminum die-cast construction makes it last a long time. For use on bar strainers and the large end to fit on the shower drain, it has a double-ended design.
Do you use plumbers putty on tub drain?
Plumber’s putty and silicone can both be used to seal cracks, but they are not the same thing. If you are using silicone, be sure to use it in a well-ventilated area. If you have any questions or comments about this article, please leave them in the comments section below.
