Kit recommends temporary use to no more than 100 miles or 3 days from date of the tire fix, and the Slime Flat Tire Repair Kit Digital Series claims use for up to 1,000 miles. For more information, visit www.slimesmartspair.com.
Table of Contents
How much Slime do you put in a tire?
You only need about 2 oz. of slime per 12″ tire, so the 8 oz. bottle sold in the bicycle section of your local grocery store will do the trick. If you want to make your own slime, you’ll need a food processor, a blender, and a large bowl. You’ll also need to buy a container to put the slime in.
I like to use a plastic container with a lid, but you can use any container you’d like. Just make sure the container is large enough to hold the amount of liquid you’re going to be making. If you don’t have one of these containers handy, just make a small bowl out of a paper towel and pour the liquid into it.
Why can’t I pump my Schrader valve?
Sounds like the valve has stuck shut, this can happen if the rubber seal at the base of the valve swells up. The valve tool and replacement core are both cheap if the valve core is replaceable. It is likely that a replacement tube will be required. You should save this one for when you need it.
Rated 5 out of 5 by HomeDepotCustomer from I bought this valve to replace an old one that was leaking. It was easy to install, and I was able to get it to work without any problems. The only thing I didn’t like about it was that I had to remove the old valve and replace it with the new one. I would recommend this product to anyone who is looking for a valve replacement.
Is Slime a good tire sealant?
In our testing, we found that Slime and other thicker gel based tire sealant do not have the strength to hold the sealant in place and only provide a temporary repair. If you have a tire that has been punctured, we recommend that you replace it with a new tire.
Can you still get a puncture with Slime?
Slime helps with punctures but it also causes problems with valves, even the pre-filled tubes. On the ride after a tire pressure check and inflation. Carry some spare valves and a removal tool if you use it.
If you don’t have a puncture repair kit, you can use the same method as described above but you will need to remove the tyre from the rim first. This is a bit of a pain but if you have the right tools you should be able to get it done in a matter of minutes.
How long does Slime last for?
Slime doesn’t go bad, but you may want to toss it if it develops mold or if it dries out. Refrigerated slime, kept in a baggie, should last for a couple of weeks and can last months in a sealed bag unrefrigerated. It should not spoil if it contains borax.
Can Slime be used with Schrader valves?
The white tube is perfect over the valves. Presta valve adapter to the white tube for a tighter fit if you have Presta valves. Fill the reservoir with water and let it sit for at least 30 minutes to allow the water to soak into the valve and seal the seal.
The water should be about 1/2 to 1 inch deep, depending on the size of your reservoir and the type of valve you are using. You may need to add a little more water if your water level is too low or too high.
What is the difference between Presta and Schrader valves?
Presta valves are longer and slimmer, while the schrader valve is shorter and thicker. The valves work differently in how they inflate, deflate and release air because of the proportions.
