By draining and refilling with fresh water on a regular basis, you’ll ensure your hot tub is clean, clear and safe. The hot tub should be drained and refilled every three or four months with average use. Drain and refill your tub every 3 to 4 months, depending on the size of the tub and the amount of water in it.
If you have a large tub, it may be best to drain it once a month, while smaller tubs may need to refill it every other month or so. You may also want to check with your local water company to see if they offer a refill program for your particular tub size.
Table of Contents
How do you fill a hot tub after draining it?
Filter retaining cap from the spa filter. Place hose inside the filter standpipe. When the water level is either: 1/3 way up tile; up to water imprint; covers all jets completely plus an inch; or touching the top of the tile. FILL the spa with water until it is completely filled. If the water is not completely full, add more water.
Do not add water to a spa that has already been filled, as this may cause the filter to become clogged and block the flow of water through the system. If you do not fill the entire spa, you may need to add additional water, depending on the size of your spa. For example, if you have a 2,000 square foot spa and you fill it with 1,500 gallons, then add another 500 gallons to make up for the empty space.
How long does it take to drain and refill a hot tub?
Depending on the size of your spa, it should take around an hour to drain using the hot tub’s drainage spigot, or ten minutes to do the same with the cold tub. If you have a large spa with a lot of sinks and tubs, you may want to invest in a separate drain for each one. This will save you time and money in the long run.
Do you fill a hot tub with a hose?
You can fill your hot tub with water from a garden hose. It is possible to prevent an airlock in your circulating pump if you fill through the skimmer basket. If your spa is equipped with one, turn the thermostat at the equipment system in the cabinet and at the command center. Unplug all electrical equipment from the spa’s power supply.
Disconnect all power cords from spa equipment. Remove all spa towels, shower curtains, hair dryers, etc. 6. Do not use any spa products on your skin. Wash your hands thoroughly with soap and water. Avoid contact with your eyes, nose, mouth, or any other part of your body. If you have a fever, call your doctor immediately.
For more information, contact your local health department or the U.S. Centers for Disease Control and Prevention (CDC) at 1-. For more information, contact your local health department or the U.S. Centers for Disease Control and Prevention (CDC) at 1-.
What chemicals do I add to my hot tub after filling?
When you fill or refill your spa pool, it needs to be treated with a high dose of sanitiser. You should aim to add 40g of chlorine per 1000l of water in the beginning, and let the level go down by the end of the treatment.
The amount you add depends on the size of your pool and the type of treatment you want to achieve. If you are treating a larger pool with chlorine, then you will need to increase the amount by a factor of 2-3.
How long can you leave a hot tub without chemicals?
No problem if you don’t want to put any chemicals in the hot tub. You must drain down and refill after each use to make sure the water is never in the spa for more than a few minutes.
How long does it take to drain a hot tub with a garden hose?
The draining process can take up to 2 hours, but you don’t need to watch it if it is properly set up. You should be able to see the water coming out of the drain after 1-2 weeks if you check back periodically and make sure the hose is draining to the correct location.
How do you drain a hot tub with a hose?
The hot tub has a drainage valve. Depending on the size of your tub and the amount of water in it, the process may take an hour or so. If you have a large tub, you may be able to do this in less than 30 minutes. If you do not have access to the drain, or if the tub is too small, then you will need to fill it with water.
This can be done by filling a bucket with about 1/2 to 3/4 of a gallon (3 to 5 liters) of warm water and placing the bucket in the bathtub. You can also fill a tub with hot water from a faucet, but be careful not to overfill it, as this can cause a fire hazard.
How do you fill a hot tub in the winter?
It’s easier to fill up your hot tub when you keep a hose in your house during the winter. You will need to thaw the outside water spigot with hot water to unfreeze the tap, and then hook up your hose and fill it up with cold water.
If you are using a water heater to heat your home, make sure that it has a thermostat that allows you to set it to a temperature that is comfortable for you and your family. If you don’t have one, you can use a thermometer to check the temperature of the water inside the heater.
Can you drain a hot tub on grass?
Chlorine and bromine are harmful chemicals that can kill your grass and make your lawn discolored. Run your hose or drain away from the grass and vegetation and away from the foundation of your house. If you have a pool, make sure that the water is not too hot or too cold.
If it’s too warm, it will not be able to evaporate enough water to keep your pool clean. Too cold, and the pool will be too hard to clean, which can lead to mold and mildew growth.
How do you drain a hot tub fast?
Just long enough to let the hose prime and get the flow moving, and turn it on for a few seconds. The water can flow out of the tank if the vacuum is turned off and the hose is disconnected. If you’re using a vacuum pump, you’ll want to make sure the pump is turned off before you turn it back on.
If you don’t do this, the pressure will build up and you won’t be able to remove the excess water from the system. You can also use a hand pump if you have one, but be careful not to over-pressurize it, as this can lead to a loss of pressure and damage to your pump.
