To adjust the temperature supply remove the plastic cap on top of the valve and adjust with a close fitting spanner. To increase the temperature, turn anti-clockwise, to decrease the temperature, and to set the valve to a maximum recommended mixed water temperature of 60C. The valve can be adjusted to any desired temperature by turning the knob on the left side.
Table of Contents
How do you adjust an anti-scald valve on a Moen bathtub?
To adjust the Temperature Limit Stop, with the handle removed, loosen the adjustment hex screw with a 7/64″ hex wrench and slide the screw downward. Tighten the hex screw. The dial on the thermostat should be turned if you want to check the hot water temperature. If the temperature is within the desired range, you are good to go.
If the thermometer does not read the correct temperature, or if it reads too high or too low, it is likely that the water is too hot. To correct the problem, turn off the heater and turn it back on. Turn the heat switch to the “on” position, then turn the switch back to “off” to return to normal operating temperature.
Can an anti-scald valve be adjusted?
The temperature could increase or decrease depending on the notch on the valve. If you are using a water heater, turn the heater to its highest setting. If you’re using an electric water heating system, use the lowest setting possible.
What temperature is an anti-scald device set to?
If you want to cut the risk of scalding in the shower, you should set your water heater to a temperature of 100F or lower. If you have a hot water system, you can also use a thermostat to control the water temperature in your shower. If you don’t have one of these devices, the best thing to do is turn down the heat as much as possible.
What height should a tub valve be set at?
A shower valve and spout should be at least 38 to 45 inches above the ground. If you do not have access to a shower or tub, you can use a water heater to heat the water in your home. You can also use an air conditioner to keep the temperature at a comfortable level.
What height do you set a tub valve at?
The average height for a shower valve is 30-50 inches above the floor, though this is a general range. The height for a tub-shower unit can be a few inches about the tub or directly on the tub as shown in the picture below. Shower valves are usually made of steel or cast iron, but they can also be made out of plastic, wood, or other materials. The most common materials used are stainless steel, aluminum, brass, and copper.
Stainless steel is the most commonly used material for shower valves because it is corrosion resistant and has a high melting point. Aluminum and brass are the least common, as they are more brittle and can break easily. Copper is also used in some shower-valve units because of its resistance to corrosion and its ability to withstand high temperatures.
Can a shower mixing valve be adjusted?
The mixture of hot water and cold water available in a shower or tub can be adjusted at the shower valve stem, allowing you to adjust the temperature of the water to suit your needs. You can also use a thermostat to control the amount of water you use in your shower.
